Fine tuning the frames.

Spent most of the past 2 days setting the proper angles and lengths for each frame. I want a nice, tight fit to help everything form into a strong whole when it is under the strain of a strong wind.

The most important tool in the operation is what I call a bevel finder. It sets to an angle with a thumb screw to hold it. I can then set the protractor on the table saw and cut very precise angles. Here is a picture of frame #2, just where the boat begins to widen.



The next step is to begin to add pieces to hold the frames together called gussets and floors. These will provide reinforcement and rigidity to the frame as well as strength and a place to "land" and secure other parts.